SSANGYONG Rexton Y200 Manual page 673

SSANGYONG Y200
DIESEL ENGINE CONTROLS 1F3-49
Tools Required
000 589 00 68 00 Cleaning Set
Repair Procedure
1. Clamp the nozzle holder (1) in a vice and remove
the nozzle tensioning nut (8).
Notice: Use protective jaws for clamping.
2. Disassemble the fuel injection nozzle.
YAD1FCB0
3. Clean the nozzle needle (6) and nozzle body (7)
with an abradant.
4. Clean the nozzle seat with cleaning cutter.
YAD1FCC0
5. Immerse nozzle needle (6) and nozzle body (7) in
filtered diesel fuel. When the nozzle body is held
vertical, the weight of the nozzle needle must
cause it to slide down toward the nozzle needle
seat.
YAD1FCD0
6. Assemble the injection nozzle so that the tip of
the thrust (4) pin is facing toward the nozzle holder.
Installation Notice
Tightening Torque
Nozzle needle (6) and nozzle body (7) should
always be replaced as a pair.
YAD1FCE0
80 N•m (59 lb-ft)