Dtc 141/146-Left Rear Prime Line And Tcs Pilot Valve Fault - SSANGYONG Rexton Y200 Manual

DTC 141/146 - Left Rear Prime Line and TCS Pilot Valve Fault
Step
1. Raise and suitably support the vehicle at the
corner being tested.
2. Turn the ignition to ON.
Important: Do not step on the brake pedal at any
time during this test.
3. Install the scan tool to the data link connector
1
(DLC).
4. Select the TCS function and "Wheel rear left" to
begin the solenoid tests at that wheel. This will test
both the prime and pilot valves.
5. When the scan tool indicates a pressure increase,
attempt to rotate the wheel.
Can the wheel be rotated?
When the scan tool indicates that the prime valve was
turned OFF, attempt to rotate the wheel again.
2
Can the wheel be rotated now?
When the scan tool indicates that the pilot valve and
the pump motor were switched OFF, attempt to rotate
3
the wheel again.
Can the wheel be rotated?
1. Clear all DTCs.
2. Road test the vehicle.
4
Does the DTC set again?
1. Check the wiring harness and connector terminals
for an intermittent problem.
5
2. Repair any problem found.
Is the repair complete?
Replace the ABS unit.
6
Is the repair complete?
SSANGYONG Y200
Action
ABS AND TCS 4E-73
Value Yes
- Go to Step 6
- Go to Step 6
- Go to Step 4
- Go to Step 6
- System OK
- System OK
No
Go to Step 2
Go to Step 3
Go to Step 6
Go to Step 5
-
-