Assembly Procedure - SSANGYONG Rexton Y200 Manual

Hide thumbs Also See for Rexton Y200:

Table of Contents

SSANGYONG Y200

AUTOMATIC TRANSMISSION 5A-173

ASSEMBLY PROCEDURE

Transmission

Tools Required

The transmission is assembled in modular fashion

and details of assembly for each module are given

under the appropriate subject.

Technicians overhauling these transmissions will

also require a selection of good quality Torx bit

sockets, in particular numbers 30, 40 and 50, and

an 8 mm, 10 mm and 12 mm double hex socket.

Ensure that the B1R circlip is fitted to the case. (If

this is not fitted, the valve will peen its way into

and through the separator plate)

Ensure that the 'E'clip is fitted to the cross shaft.

Ensure that all aspects of the parking mechanism

are working.

1. Turn the transmission case upside down on the

bench and mount it to the transmission bench cradle

0555-336256.

2. Install all fittings, plugs and the breather, applying

a sealant where applicable, Tighten the fittings to

specifications. Ensurethatthebreatheris clear,

andcheckthat the lube fitting in the rear of the case

is fittedand clear of obstruction.

3. Assemble the B1R valve and spring, and secure

with the circlip. Ensure that the circlip is completely

seated in its groove.

Transmission Bench Cradle

Cross Shaft Pin Remover/Installer

(Detent Lever)

Cross Shaft Seal Installer

Cross Shaft bullet

Cross Shaft Pin Remover/Installer

(Inhibitor Switch)

Table of Contents