Table of Contents
Advertisement
1F3-14 DIESEL ENGINE CONTROLS
EGR Micro Switch Setting Procedure
Tools Required
617 589 08 21 01 Micro switch Setting Device.
In turbo equipped vehicle, the timing of injection pump must be adjusted after repairing or replacement as
follows:
1. Hold the injection with clamp (special) on the work bench.
2. Install the micro switch setting device 017 589 08 21 01 in the injection pump.
3. Adjust and fix the lever (6) at 10° ± 1 °
4. Insert the harness into the micro switch setting device 617 589 08 21 01.
5. Install the cam on the injection pump when the both lamps are "on".
6. Install the screw.
7. At this moment, loosen the clamp and insert the adjusting disc "A" to the lever and check again.
8. If the lamp "A" is "on", the setting is correct, thus, timing of injection pump is OK.
If the both lamps are "on", perform the setting as above procedure.
SSANGYONG Y200
Advertisement
Chapters
Table of Contents
