Purge Control Valve; Canister; Camshaft Position Sensor - SSANGYONG Rexton Y200 Manual

1F1-92 M162 ENGINE CONTROLS

PURGE CONTROL VALVE

Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the purge control valve connector.
3. Disconnect the throttle body-to-purge control valve
hose from the purge control valve.
4. Disconnect the canister-to-purge control valve
hose from the purge control valve.
5. Remove the purge control valve.
6. Installation should follow the removal procedure
in the reverse order.
YAD1F650

CANISTER

Removal and Installation Procedure
Caution: Canister and vacuum hoses contain fuel
vapors. Do not smoke in the area or permit an open
flame.
1. Disconnect the fuel tank-to-canister hose form the
canister.
2. Disconnect the canister-to-purge control valve
hose form the canister.
YAD1F660
3. Remove the canister mounting bolts.
Installation Notice
Tightening Torque
4. Remove the canister.
5. Installation should follow the removal procedure
in the reverse order.
YAD1F670

CAMSHAFT POSITION SENSOR

Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector from the
camshaft position sensor.
3. Remove the camshaft position sensor retaining
bolt.
Installation Notice
Tightening Torque
KAA1F170
6 N•m (53 lb-ft)
10 N•m (89 lb-ft)
SSANGYONG Y200