Brake Pedal - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200
For Master Cylinder Replacement
1. Add oil after master cylinder replacement.
2. Run the engine and depress the brake pedal
several times to build pressure and then keep the
pedal fully depressed.
3. Loosen the screw of primary and secondary pipe
at the master cylinder outlets to bleed air.
4. Repeat above step No.3 several times until there
are no more air bubbles.
5. Bleed air in the system at the hydraulic unit outlet
pipe and wheel if pressure building is not enough
by depressing the pedal only after above air
YAD4A090
bleeding.
For Hydraulic Unit Replacement
1. Add oil after hydraulic unit replacement.
2. Run the engine and depress the pedal several
times to build pressure and then keep the pedal
fully depressed.
3. Loosen hydraulic pipe screws at the hydraulic unit
outlets to bleed air.
4. Repeat above step No.3 several times until there
are no more air bubbles.
5. Bleed air in the system from the wheel if pressure
building is not enough by pressing the pedal only
after above air bleeding.
YAD4A100

BRAKE PEDAL

Pedal Travel Check
1. Start the engine.
2. Push the pedal three times.
3. With the brake depressed by about 30 kg (66.15 lb)
load, measure the clearance between the pedal
pad and the lower dash panel.
4. Check pad or shoe wear, any leak for the brake
system when the measured value is below the
specified value.
5. If the pedal height is not in the specified value,
YAD4A110
loosen the lock nut of the brake booster push rod
and adjust the push rod length.
BRAKE SYSTEM 4A-7