SSANGYONG Rexton Y200 Manual page 250

SSANGYONG Y200
M161 ENGINE MECHANICAL 1B2-89
Tools Required
103 589 02 09 00 Oil Filter Remover
Replacement Procedure
1. Install the oil filter remover 103 589 02 09 00 on
the oil filter cover.
Notice: Make the screw cover removable by
tightening the bolt at the side of the oil filter
remover 103 589 02 09 00.
2. Install the wrench to the upper bolt in the oil filter
remover 103 589 02 09 00 and remove the oil cover
by turning it.
YAD1B7S0
3. Remove the oil filter element.
Notice: Work with a cloth under the vehicle when
removing the oil filter element to not drain the oil.
4. Remove the drain plug and drain the engine oil.
Notice: Leave the oil filler cap open to ease the
engine oil discharge.
5. Tighten the engine oil drain plug after cleaning it.
Installation Notice
Tightening Torque
Replace the seal washer with new one.
6. Replace the O-ring in the oil filter cover with new
one.
Notice: Apply the engine oil to the O-ring.
YAD1B7T0
7. Insert new oil filter element into the oil filter
housing.
8. Temporarily tighten the oil filter cover. Install the
Oil filter remover 103 589 02 09 00, and then
completely tighten it.
Installation Notice
Tightening Torque
25 N•m (18 lb-ft)
25 N•m (18 lb-ft)