SSANGYONG Rexton Y200 Manual page 1036

5A-168 AUTOMATIC TRANSMISSION
9. Invert the clutch cylinder and remove the C4 clutch
sleeve, clutch plates and the two wave washers.
The 3-4 one way clutch is located between the C2
and C4 clutch hubs, and the hubs may be
separated by rotating one hub clockwise and
withdrawing it from the other.
10. Remove the thrust block from the C4 clutch
cylinder hub.
KAA5A680
11. Mount the clutch cylinder on clutch spring
compressor 0555-336259 with the C2/C4 end
uppermost and compress the piston return spring.
Remove the spring retaining circlip. Release the
tool and remove the circlip, keeper and spring.
Notice: Make sure that the spring keeper is not
caught in the circlip groove, and that all the spring
pressure is released, before removing the tool.
12. Invert the clutch cylinder on the compressor tool
and removethe C1 clutch piston return spring in
asimilar manner.
KAA5A690
13. To remove the clutch pistons from the clutch
cylinder, apply air pressure to the apply ports in
the bore of the cylinder.
KAA5A700
C3 Clutch Cylinder
Tools Required
0555-336259 Clutch Spring Compressor
1. Remove the forward sun gear, No.7 needle bearing
(2) thrust washer (1) and lipped thrust washer (3)
from the C3 clutch cylinder.
2. Remove the thrust plate (4), No.6 needle bearing
(5), thrust plate (6) and nylon thrust plate (7) from
the clutch cylinder hub.
3. Remove the clutch plate retaining circlip and re-
move the clutch plates.
KAA5A720
SSANGYONG Y200