SSANGYONG Rexton Y200 Manual page 362

1B3-94 DIESEL ENGINE MECHANICAL
Tools Required
102 589 03 40 00 Magnetic Bar
116 589 06 63 00 Magnetic Finger
601 589 01 59 00 Assembling Board
601 589 02 59 00 Supporting Bridge
667 589 00 31 00 Press Lever
Removal & Installation Procedure
1. Remove the nuts (8) uniformly and then remove
the washer (7), exhaust manifold (9) and gasket.
Installation Notice
YAD1BG70
Check the stud bolt (6) for damage and replace if
necessary.
Tightening Torque
Replace the gasket and tighten the nuts (8).
Tightening Torque
2. Install the assembling board 601 589 01 59 00
(11) to the cylinder head with 4 cylinder head blots
(10).
YAD1BG80
3. Pull out the valve tappet (1) with magnetic bar
102 589 03 40 00 (12).
Notice: Place the valve tappets upside down
(open end upward).
YAD1BG90
4. Install the supporting bridge 601 589 02 59 00
(13) on the cylinder head (5).
YAD1BGA0
12 N•m (106 lb-in)
25 N•m (18 lb-ft)
SSANGYONG Y200