SSANGYONG Rexton Y200 Manual page 1070

Hide thumbs Also See for Rexton Y200:

Table of Contents

5A-202 AUTOMATIC TRANSMISSION

1. Measure distance'A' from the rear servo piston to

the inner face of the transmission case using vernier

a. Apply air at 650/700 kPa to the rear servo apply

area (B2 outer)

b. Measure the travel of the piston, subtract 3.75

mm and divide the remainder by 2.5 to find shim

c. Release the air.

Notice: A minimum of one shim is required at all times

- minimum shim size is 1 mm. The thickness of

available shims are listed in the table below.

Thickness(mm)

Rear Band Setting Procedure

2. Fit the selected shim(s) to the shank of the anchor

3. Re-check that the piston travel.

strut as follows.

a. Inspect the shim(s) for damage, wear or

corrosion and replace as necessary. The shim(s)

are to be installed between the case abutment

face and the anchor strut flange.

b. The shim(s) are to be fitted by hand and under

no circumstances to be hammered or forced

c. The shim(s) are to be pressed on by hand until

an audible click is heard. The click indicates

that the shim is clipped home correctly.

(3.75 mm ± 0.625 mm)

SSANGYONG Y200

Chapters

Table of Contents