SSANGYONG Rexton Y200 Manual page 342

1B3-74 DIESEL ENGINE MECHANICAL
14. Measure crankshaft bearing journal diameter (F).
Notice: When measured in A and B, the runout
should not exceed 0.010 mm.
YAD1BEU0
15. Measure radial clearance of crankshaft bearing
(G).
Clearance 'G'
Notice: If 'G' is out of standard, replace the
bearing shells and adjust the radial clearance of
crankshaft bearing.
Example) Measured value 'E' = 57.700 mm
YAD1BEV0
16. Remove the crankshaft bearing cap.
17. Measure width of thrust bearing journal (H) and
adjust with proper thrust bearings (see table).
Notice: The same thickness of thrust washers
should be installed on both sides of the thrust
bearing.
YAD1BEW0
18. Coat the upper thrust bearing (4) with oil and insert
into the crankcase so that the oil grooves are facing
the crank webs (arrow).
YAD1BEX0
0.027 - 0.051 mm
Measured value 'F' = 57.659 mm
Clearance 'G' = 0.041 mm
SSANGYONG Y200