SSANGYONG Rexton Y200 Manual page 1116

5B-30 MANUAL TRANSMISSION
Assembly Procedure
1. Using a hydraulic press and a supporting tool,
press the counter shaft rear bearing into the case.
Be sure that the supporting tool inside of the case
should support the counter shaft.
YAD5B710
2. Without the shim, install the retainer and counter
shaft rear bearing outer race. Tighten the 4 retainer
bolts.
Installation Notice
Tightening Torque
YAD5B720
3. Place a dial indicator on the case and measure
counter shaft end play by moving up and down.
YAD5B730
4. Select a shim which is the same thickness as the
indicator rearing (up to 0.004 inch) and assemble
it.
5. When the end play is correctly adjusted, remove
the counter shaft rear bearing retainer and outer
race.
6. Using a pin punch and rubber hammer, install the
reverse idler shaft, gear and O-ring.
YAD5B740
20 N•m (15 lb-ft)
SSANGYONG Y200