1B2-48 M161 ENGINE MECHANICAL
Removal & Installation Procedure
1. Unscrew the flywheel mounting bolt.
Installation Notice
Tightening Torque
•
Replace the bolt when the stretch side diameter
(d) of the flywheel mounting bolt is less than
8.0mm.
•
For the flywheel mounting bolt tightening, keep
the socket wrench and Tommy-bar to be 90 ° and
tighten as specified.
2. Remove the flywheel for manual transmission ve-
hicles, or the driven plate (3), and plate (2) for
Auto transmission vehicle.
3. Installation should follow the removal procedure
in the reverse order.
1st step: 45 + 5 N•m
(33 + 3.7 lb-ft)
2nd step:90° ± 10°
SSANGYONG Y200