SSANGYONG Rexton Y200 Manual page 871

4C-18 REAR BRAKE
8. Disconnect the brake lining and adjuster lever.
YAD4C360
9. Remove the wheel cylinder mounting bolt and
remove the wheel cylinder.
YAD4C370
Inspection
1. Measure the inside diameter of the brake drum
and replace as needed.
Ø 254 mm
Notice: Measure two more position.
YAD4C380
2. Inspect the surface between the lining and brake.
Mark the brake drum inside using chalk and scrub
the shoe & lining assembly. If there is excessive
contact problem, replace the shoe & lining
assembly or the brake drum.
Notice: Clean any chalk mark after inspection
complete.
YAD4C390
I.D. Wear Limit
Ø 255.5 mm
SSANGYONG Y200