Table of Contents
Advertisement
4E-30 ABS AND TCS
Electronic Brake-Force Distribution System (EBD) Indicator Lamp Inoperative (Cont'd)
Step
Check the wiring harnesses and connectors in circuit
from the I/P cluster terminal A6 to terminal 21 of the
14
EBCM connector.
Is the voltage equal to the specified value?
Repair the open or high resistance.
15
Is the repair complete?
Check for continuity between terminal 16, 19 of the
ABS connector and ground G106.
16
Is the continuity equal to the specified value?
Replace the ABS unit.
17
Is the repair complete?
Repair the continuity between terminal 16, 19 of the
EBCM connector and ground G106.
18
Is the repair complete?
1. Turn the ignition to LOCK.
2. Check fuse F2 in the I/P fuse block.
19
Is fuse F2 blown?
Replace fuse F2.
20
Is the repair complete?
1. Turn the ignition ON.
2. Check the voltage at fuse F2.
21
Is the voltage equal to the specifies value?
Repair the power supply to fuse F2.
22
Is the repair complete?
1. Remove the I/P cluster.
2. Check circuit from fuse F2 to terminal 15 of the I/P
cluster connector.
23
3. Repair any open or high resistance found in a
wiring harness, a splice pack, or a connector.
Is the repair complete?
Action
Value
Yes
∞
Go to Step 15
-
System OK
≈ 0 Ω
Go to Step 17
-
System OK
-
System OK
Go to Step 20
-
-
System OK
11 - 14 V
Go to Step 22
-
System OK
-
System OK
No
Go to Step 16
-
Go to Step 18
-
-
Go to Step 21
-
Go to Step 23
-
-
SSANGYONG Y200
Advertisement
Chapters
Table of Contents
