Table of Contents
Advertisement
DTC 060/065 - Left Front Inlet and Outlet Valve Solenoid Fault
Step
1. Raise and suitably support the vehicle at the
corner being tested.
2. Turn the ignition to ON.
3. Install the scan tool to the data link connector
(DLC) and select "Wheel front left" to begin the
solenoid tests at that wheel. This will test both the
1
inlet and the outlet valves.
4. When the scan tool indicates "Pressure hold,"
press and hold the brake pedal until the end of the
test.
5. Have an assistant attempt to rotate the wheel.
Can the wheel be rotated?
1. Maintain pressure on the brake pedal.
2. When the scan tool indicates "Pressure increase,"
have an assistant attempt to rotate the wheel
2
again.
Can the wheel be rotated now?
1. Maintain pressure on the brake pedal.
2. When the scan tool indicates "Pressure release
on," have an assistant attempt to rotate the wheel
3
again.
Can the wheel be rotated?
1. Release brake pedal pressure when the scan tool
indicates "Pressure release off"
2. Clear all DTCs.
4
3. Road test the vehicle.
Does the DTC set again?
1. Check the wiring harness and connector terminals
for an intermittent problem.
5
2. Repair any problem found.
Is the repair complete?
Replace the ABS unit.
6
Is the repair complete?
SSANGYONG Y200
Action
ABS AND TCS 4E-65
Value
Yes
-
Go to Step 2
-
Go to Step 6
-
Go to Step 4
-
Go to Step 6
-
System OK
-
System OK
No
Go to Step 6
Go to Step 3
Go to Step 6
Go to Step 5
-
-
Advertisement
Chapters
Table of Contents
