SSANGYONG Y200
GENERAL INSPECTION
Inspection Tread
Inspect the tread condition on the tire surface and
various damages resulting from the foreign material,
crack, stone or nail etc. If there is any damage in the
tire, repair or replace it.
Tire Wear
•
Measure the depth of the tire tread. If the depth
of the tread is below the specified value, replace
the tire.
Limit of the Tread Wear
•
You can see the mark ' ' in the groove, this is the
indicator of the tread wear limit.
•
The limit of the tread wear for all season tires are
1.6 mm as same as the general tires and the
platform mark indicates as '↓' .
YAD2E220
Inspection the Inflation of Tires
1. Inflation pressure
Front/Rear
YAD2E230
2. Inspect the pressure of the tire surface and check
the inflation pressure.
Notice:
•
Lower than recommended pressure can cause
tire squeal on turns, hard steering, tire cord
breakage and tire rim bruises, etc.
•
Higher than recommended pressure can cause
hard ride, tire bruising or damage and rapid
tread wear at the center of the tire.
YAD2E240
TIRES AND WHEELS 2E-9
1.6 mm (0.06 in.)
2
2.1 kg/cm
(30 psi)