SSANGYONG Rexton Y200 Manual page 1045

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-177
Rear Band Assembly
1. Check the rear band for any cracks or damage along
the lining and metal backing.
2. Install the reaction anchor strut into the main case,
without shims.
3. Carefully install the rear band into the transmission
case and ensure that it is properly fitted in the case.
Notice: If fitting a new band, soak the new band in
automatic transmission fluid for a minimum of five
minutes prior to assembly.
KAA5A950
4. Position the apply strut on the rear band then
engage the apply strut in the servo lever.
5. Install the cam plate and tighten the screws to
specification.
Installation Notice
Tightening Torque
KAA5A960
Rear Servo Assembly
1. Check the servo piston 'O' rings and gasket for
any damage.
2. Lubricate the servo piston 'O' rings with automatic
transmission fluid, and fit the 'O' rings to the piston
grooves.
3. Assemble the piston to the cover, ensuring that 'O'
ring compression is adequate but not excessive.
4. Align the spring on the piston spigot, then position
the rear servo rod into the spigot.
KAA5A630
5. Assemble the gasket to the cover and fit the assem-
bly to the case.
Notice: Do not use petroleum jelly on the gasket.
6. Apply additional Loctite 202 or equivalent as
required to the rear servo to case bolts. Install the
bolts and tighten to specification.
Installation Notice
Tightening Torque
KAA5A990
16-22 N•m (12-16 lb-ft)
30-35 N•m (22-26 lb-ft)