Crankshaft Position Sensor; Engine Control Module - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200
M161 ENGINE CONTROLS 1F2-95
4. Check the O-ring for damage and replace it if
necessary.
5. Installation should follow the removal procedure
in the reverse order.

CRANKSHAFT POSITION SENSOR

Removal and installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector at the crankshaft
position sensor.
3. Remove the crankshaft position sensor retaining bolt.
Installation Notice
Tightening Torque
4. Installation should follow the removal procedure
in the reverse order.
KAA1F160

ENGINE CONTROL MODULE

Removal and installation Procedure
1. Disconnect the negative battery cable.
2. Remove the cowl side trim form passenger side.
Re-er to Section 9G, Interior trim.
3. Remove the four securing nuts for the Engine
Control Module (ECM) from the mounting bracket.
Installation Notice
Tightening Torque
4. Pull out the ECM from the bracket.
KAA1F200
5. Disconnect the vehicle side coupling.
6. Installation should follow the removal procedure
in the reverse order.
10 N•m (89 lb-in)
10 N•m (89 lb-in)