SSANGYONG Rexton Y200 Manual page 109

1B1-68 M162 ENGINE MECHANICAL
8. Unscrew the intake side bolts (8, 11, 13, 14) and
the exhaust side bolts (1, 4, 6, 7).
9. Loosen the remaining bolts and unscrew the intake
and exhaust side camshaft bearing cap bolts.
Notice: Number the camshaft bearing cap bolts
when removing them, so that they don't get mixed
up.
10. Remove the intake and exhaust camshafts.
YAD1B0M0
Installation Procedure
1. Turn the crankshaft and position the No. 1 cylinder
piston at BTDC 30°.
Notice: Turn the crankshaft in the direction of
engine rotation.
2. Install the exhaust camshaft bearing caps (2, 3,
5) and the intake camshaft bearing caps (9, 10,
12). Tighten the bolts with specified torque and
install the remaining bearing caps.
Installation Notice
Tightening Torque
Install the bearing caps according to the numbers
on the bearing caps.
YAD1B0N0
3. Turn the camshaft using the wrench so that the
intake camshaft adjustment hole lines up with the
cylinder head upper side (3 o'clock direction at
the intake, 9 o'clock direction at the exhaust).
Notice: Turn the crankshaft and adjust it to OT so
that No. 1 cylinder's piston would be at TDC.
YAD1B0P0
22.5 - 27.5 N•m
(16.6 - 20.3 lb-ft)
SSANGYONG Y200