Step
Examine the acceleration sensor.
1
Are there any signs of physical damage?
1. Turn the ignition switch to ON.
2. Use a digital voltmeter (DVM) to measure the
2
voltage between terminal 28 and 23 of EBCM.
Is the voltage within the specified value?
Replace the acceleration sensor.
3
Is the repair complete?
Repair the open in the affected circuit or replace the
acceleration sensor, if necessary.
4
Is the repair complete?
1. Place the acceleration sensor horizontally and let
the acceleration sensor.
2. Turn the ignition switch to ON.
5
3. Use a digital voltmeter (DVM) to measure the
voltage between terminal 28 and 10 of EBCM.
Is the voltage within the specified value?
Repair the open in the affected circuit or replace the
acceleration sensor, if necessary.
6
Is the repair complete?
Replace the ABS unit.
7
Is the repair complete?
SSANGYONG Y200
DTC - Acceleration Sensor Continuity Fault
Action
ABS AND TCS 4E-63
Value
Yes
-
Go to Step 3
4.75 - 5.25 V
Go to Step 5
-
System OK
-
System OK
1.95 - 3.45 V
Go to Step 7
-
System OK
-
System OK
No
Go to Step 2
Go to Step 4
-
-
Go to Step 6
-
-