Table of Contents
Advertisement
Diagnostic Aids
DTC 11 may be set by running the scan tool auto test
if the throttle angle readings are not updating while in
the date list mode. If this is the case, clear the DTCs,
disconnect the scan tool, and road test the vehicle to
at least 25 km/h (15 mph) to see if the DTC resets.
Check the toothed wheels for any large grooves,
gouges, marks, etc. that might influence the tooth's
signal at the wheel speed sensor. Also, check for a
buildup of foreign material in the gaps between the
Step
Visually inspect the wiring for the front wheel speed
sensors.
1
Is there any damage?
Repair or replace components, as required.
2
Is the repair complete?
Check that the correct outer constant velocity (CV)
joints are installed on the vehicle, They should have
3
speed rings with 52 teeth.
Is one of these incorrect?
Replace the incorrect outer CV joint with the proper
4
unit.
Is the repair complete?
1. Disconnect the wheel speed sensor harnesses
from the wheel speed sensor connectors.
2. Measure the wheel speed sensor resistance at the
5
wheel speed sensor connector terminals.
Does the resistance fall within the specified values for
both wheel speed sensors?
Replace the faulty wheel speed sensor.
6
Is the repair complete?
1. Disconnect the ABS control module connector.
2. Check each wheel speed sensor harness for a
short circuit between its wires with a digital
7
ohmmeter attached to the two terminals at the
harness side of the wheel speed sensor connector.
3. Also check each wheel speed sensor harness wire
for a short to ground from the connector terminals.
Is there any short circuit in either wheel speed sensor
harness?
Repair the short circuit tin the wiring or from a wiring
harness to ground.
8
Is the repair complete?
Check the continuity of the wiring in both front wheel
speed sensor circuits between the EBCM connector
and the wheel speed sensor connector an each side of
the vehicle.
9
•
The left side uses terminals 7 and 6 at the EBCM
connector.
•
The right side uses terminals 4 and 5 at the EBCM
connector.
Is continuity good for both harnesses?
SSANGYONG Y200
DTC 245 - Wheel Speed Sensro Frequency Error
Action
teeth in the toothed wheel, as this material may cause
this malfunction.
A badly worn hub/bearing assembly may cause this
malfunction. The wheel speed sensor-to-toothed wheel
air gap may change excessively due to bearing play.
If an improper rear hub assembly or front outer constant
velocity joint is installed, one with a toothed wheel
containing the incorrect number of teeth, this DTC can
set. Be sure that all the toothed wheels have 52 teeth.
Value
-
Go to Step 2
-
System OK
-
Go to Step 4
-
System OK
1280 - 1920 Ω
Go to Step 7
-
System OK
-
Go to Step 8
-
System OK
-
Go to Step 11
ABS AND TCS 4E-57
Yes
No
Go to Step 3
-
Go to Step 5
-
Go to Step 6
-
Go to Step 9
-
Go to Step 10
Advertisement
Chapters
Table of Contents
