SSANGYONG Rexton Y200 Manual page 152

Wear Limit in Longitudinal and Transverse Direction
Permissible Deviation of Cylinder Out-of-round
Permissible Deviation of Rectangular Cylinder Height (Except Chamfered Area)
Basic Peak-to-valley Height After Final Honing and Brushing
Chamfer Angle
Honing Angle
1,2,3. Measuring Points
A. Axial Direction
B. Transverse Direction
a. Location of the No.1 Piston Ring at TDC
b. Location of the Piston BDC
c. Location of the Oil Ring at BDC
SSANGYONG Y200
M162 ENGINE MECHANICAL 1B1-111
Service Data Standard
Measurement of Cylinder Bore
1. Clean the cylinder wall.
2. Using a internal diameter gauge, measure the bore
size in axial and transverse direction at three
points (1, 2, 3).
YAD1B4E0
Chamfer Angle
YAD1B4F0
When new 0.007 mm
Wear limit 0.05 mm
0.05 mm
0.003 - 0.006 mm
50° ± 10°
0.1 mm
60°