Spare Tire - SSANGYONG Rexton Y200 Manual

2E-14 TIRES AND WHEELS
5
2
3
1
6
4
YAD2E330
YAD2E340
YAD2E350
General Instruction
•
Clean the contact surface between the wheel and
the hub.
•
Do not apply oil or grease to the nuts and bolts
(cause the wheel to work loose).
•
Raise the tires 3 cm off the ground using the
jacket.
•
Tighten the wheel nuts diagonally as shown.
Steel Wheel: 80 - 120 N•m
Tightening
Torque
Alloy Wheel: 120 - 130 N•m

SPARE TIRE

Removal Procedure
1. Prepare the spare tire handle and the wheel nut
wrench.
2 Install the handle through the hole at the rear side
of the vehicle.
3 Install the wheel nut wrench at the end of the
handle.
4 Turn the wheel nut wrench counterclockwise until
the spare tire takes down the ground.
5 Pull out the lift plate as shown.
6 Install the lift plate in the center of the wheel for
installation.
7 Turn the handle clockwise until listen the sound
"click".
8 Remove the handle and the wheel nut wrench.
Notice:
•
Keep the spare tire available always.
•
When reinstall the spare tire, install the tire
tightly.
•
If the spare tire may move after installation,
reinstall the tire or contact to the approved
service shop for repair.
•
For installing the spare tire on the vehicle, follow
the installation direction. If you may install the
tire in reverse direction, it is not possible to
install it correctly.
SSANGYONG Y200