Crankshaft Position Sensor; Engine Control Module - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200
M162 ENGINE CONTROLS 1F1-93
4. Check the O-ring for damage and replace it if
neces sary.
5. Installation should follow the removal procedure
in the reverse order.

CRANKSHAFT POSITION SENSOR

Removal and installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector at the
crankshaft position sensor.
3. Remove the crankshaft position sensor retaining
bolt.
Installation Notice
Tightening Torque
4. Installation should follow the removal procedure
KAA1F160
in the reverse order.

ENGINE CONTROL MODULE

Removal and installation Procedure
1. Disconnect the negative battery cable.
2. Remove the cowl side trim form passenger side.
Refer to Section 9G, Interior trim.
3. Remove the four securing nuts for the Engine
Control Module (ECM) from the mounting bracket.
Installation Notice
Tightening Torque
KAA1F200
4. Pull out the ECM from the bracket.
5. Disconnect the vehicle side coupling.
6. Installation should follow the removal procedure
in the reverse order.
25 N•m (18 lb-ft)
25 N•m (18 lb-ft)