Condition
All Shifts Firm
Manual 4-3-2-1 is soft delayed or
missing
Firm 1-2 Hot
4th Tied up
Tied up on 2-3
Flare on 2-3
Slips in 4th
Slips in reverse, no manual 1st
Flare on 4-3, Flare on 3-2
Firm Manual low shift-high line
press.
SSANGYONG Y200
SHIFT QUALITY FAULTS
Possible Causes
•
Incorrect auto transmission fluid
(ATF).
•
S5 faulty won, or incorrectly
fitted.
•
Band apply and clutch apply
regulator springs misplaced.
•
Over-run Clutch (OC) /Low-1st
ball misplaced.
•
C4 clutch worn or burnt.
•
C4 wave plate not lined up with
the holes in the piston.
•
S5 worn.
•
Incorrect C4 pack clearance.
•
Damaged C4 clutch.
•
Cracked C2 piston (leaking into
C4).
•
Incorrect band adjustment
•
Front servo plastic plug missing
•
B1R spring broken.
•
B1R spring/plug left out.
•
C1/B1R ball misplaced.
•
C1 clutch damaged.
•
Restriction in C1 feed.
•
C1 piston check ball jammed.
•
Overdrive or input shaft sealing
rings damaged.
•
C1/B1R ball misplaced.
•
Overdrive or input shaft sealing
rings damaged.
•
C1 clutch damaged.
•
Rear band incorrectly adjusted
or damage
•
Low-1st check ball misplaced.
•
4-3 sequence valve in backwards.
•
Low-1st check ball misplaced.
AUTOMATIC TRANSMISSION 5A-45
•
Drain and fill with specified ATF.
•
Check that S5 is fitted correctly,
or replace S5.
•
Inspect band apply and clutch
apply regulator springs. Refit or
replace as necessary
•
Inspect the ball. Refit or replace
as necessary.
•
Inspect C4 clutch. Replace or
repair as necessary.
•
Check the alignment. Realign as
necessary.
•
Inspect S5 and replace as
necessary.
•
Check the clearance and adjust
as necessary.
•
Inspect C4. Repair or replace as
necessary.
•
Inspect piston. Repair or
replace as necessary.
•
Inspect and adjust band as
necessary.
•
Replace the plug.
•
Replace the spring.
•
Replace the spring/plug.
•
Refit the ball.
•
Inspect the clutch. Repair the
clutch as necessary.
•
Inspect and clean C1 feed.
•
Replace the piston.
•
Inspect and replace the sealing
rings and/or shaft as necessary.
•
Inspect and replace the ball.
•
Inspect and replace the sealing
rings and/or shaft as necessary.
•
Inspect and repair the C1 clutch
as necessary.
•
Inspect and adjust or replace
rear band.
•
Inspect and re-fit the ball.
•
Refit the valve.
•
Replace the ball.
Action