SSANGYONG Rexton Y200 Manual page 1043

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-175
11. Poition the manual valve detent lever, aligning it
with the cross-shaft bore in the case.
12. Push the shaft through the detent lever until it starts
in the detent lever side of the case.
KAA5A920
13. Install the detent lever drive pin in the shaft using
cross shaft pin remover/installer (detent lever)
0555-336258 with the adaptor over the pin.
14. Press the pin into the shaft until the tool bottoms.
15. Remove the tool and fit the spring retaining circlip
to the shaft.
KAA5A600
16. Install the new cross shaft seals using cross shaft
seal installer 0555-336262 (1) and cross shaft
bullet 0555-336263 (2).
KAA5A930
17. Install the inhibitor switch on the case. Torque the
bolts as per specifications. Press the pin into the
shaft until the tool bottoms using cross shaft pin
installer/ remover (inhibitor switch) 0555-336265.
Installation Notice
Tightening Torque
18. Thoroughly check the terminal wiring loom for
condition and continuity.
KAA5A580
4-6 N•m (35-53 lb-in)