SSANGYONG Y200
Inspection
1. Clean the dissembled parts and visually check
the followings;
•
Wear, rust and damage on the cylinder and
piston
•
Damage, crack on the caliper body and
damage, wear on the guide pin
•
Pad uneven wear and oil contamination
•
Boot's damage and tear
YAD4C190
2. Inspect the brake pad thickness.
Pad Thickness
Notice: If the thickness of both pads is not same,
replace both pads at the same time.
3. Inspect the disc thickness.
Pad Thickness
4. Inspect the disc plate's scratch and deformation.
YAD4C200
Brake Pad
1. Remove the cylinder mounting bolt (lower) at the
brake caliper.
2. Raise and fix the caliper assembly at the proper
position not to cause any damage in the hoses or
others.
YAD4C210
REAR BRAKE 4C-13
Max wear Limit
10 mm
Max wear Limit
10.4 mm
2 mm
8.5 mm