SSANGYONG Rexton Y200 Manual page 962

4E-84 ABS AND TCS
Step
1. Disconnect the connector from the EBCM.
2. Turn the ignition to ON.
14
3. Check the voltage between ground and terminal
17, and between ground and terminal 18.
Is the voltage within the specified value?
1. Turn the ignition to OFF.
2. Trace the WHT/RED wires between terminals 17
and 18 of the EBCM connector to fuse F7 and SB2
15
in the I/P fuse block.
3. Repair the open in this circuit.
Is the repair complete?
1. Turn the ignition ON.
2. Check the voltage at fuse SB2.
16
Is the voltage within the specified value?
Repair the power supply circuit for fuse SB2.
17
Is the repair complete?
1. Turn the ignition to OFF.
2. Check the resistance between ground and terminals
18
16 and 19 of the ABS harness EBCM connector.
Is the resistance equal to the specified value?
Examine terminals 15, 16, 17, 18 and 19 of the EBCM
connector.
19
Is there a defective terminal?
Repair the defective terminal or replace the connector
or wiring harness, as required.
20
Is the repair complete?
Repair the defective ground connection.
21
Is the repair complete?
1. Install the scan tool.
2. Clear all DTCs.
22
3. Road test the vehicle.
Does DTC 800 set again?
Replace the ABS unit.
23
Is the repair complete?
1. Examine the wiring harness and connectors for
causes of intermittent problems.
24
2. Repair any intermittent problem found.
Is the repair complete?
DTC 800 - Low Voltage Fault (Cont'd)
Action Value Yes
11 - 14 V Go to Step 16
- System OK
11 - 14 V Go to Step 18
- System OK
0 Ω
Go to Step 19
- Go to Step 20
- System OK
- System OK
- Go to Step 23
- System OK
- System OK
No
-
-
-
Go to Step 17
-
Go to Step 21
Go to Step 22
-
Go to Step 24
-
-
SSANGYONG Y200