Electronic Adjustments - SSANGYONG Rexton Y200 Manual

ELECTRONIC ADJUSTMENTS

Idle Speed Adjustments
Carry out the adjustments to the idle speed as detailed
in the workshop manual.
Vehicle Coding
The vehicle coding is integrated as part of the
diagnostic software. A scan tool has the function to
code the ve-hicle through the K-line.
Throttle Clearing
The leant throttle clearing routine uses the mode switch
and gear lever. Carry out the following steps to
complete the automated throttle clearing procedure:
1. Switch ignition 'ON' with handbrake applied and
engine 'OFF'.
2. Select the selector lever to 1st gear and 'WINTER'
mode.
3. Move the selector lever to 2nd gear and 'ECONO'
or 'POWER' mode.
4. Move the selector lever to 3rd gear and 'WINTER'
mode.
SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-41
Throttle Position Calibration
Should the throttle position data stored in the TCU be
lost or be out of specification, as indicated by a
diagnostic trouble message, it may be re-established
by the following procedure.
•
Check that the hot engine idle speed is within
specfication.
•
Allow the engine to idle in 'Drive' for 60 seconds
with the air conditioner (if fitted) turned off. The
closed throttle reference point in the TCU has now
been set.
•
Switch the engine off but leave the ignition on. Hold
the accelerator pedal on the floor for 60 seconds.
The wide open throttle reference point in the TCU
has now been set.