SSANGYONG Rexton Y200 Manual page 1039

Hide thumbs Also See for Rexton Y200:

Table of Contents

SSANGYONG Y200

AUTOMATIC TRANSMISSION 5A-171

7. Depress the plug inward and remove the retaining

pin for each of the three valves.

Notice: Some of the valves and plugs are preloaded

by springs and may unexpectedly fall out of the

cover when the pins are removed.

8. Remove the four valves, plugs and springs.

9. Remove the pump gears from the pump body.

10. Remove the lip seal from the front of the pump

1. Remove the manual valve detent spring and retain-

er plate using a T40 Torx bit.

2. Slide the manual valve out of the lower valve body.

Notice: Be aware that the manual valve will fall out

of the valve body.

3. Take note of the angular relationship of the

solenoid terminals to the valve body and remove

the solenoids 1, 2, 3, 4, 5, 6 and valve assemblies.

Notice: Take care that the bracket is not separated

from the solenoid.

4. Place the valve body assembly on the bench with

the upper body uppermost.

5. Remove the 24 clamping screws with a No. 30

Torx bit. Separate the upper and lower valve

bodies by lifting the upper body and the separator

plate togeth-er.

6. Turn the upper body over and place it on the bench

with the separator plate uppermost.

Chapters

Table of Contents