SSANGYONG Rexton Y200 Manual page 447

1F1-14 M162 ENGINE CONTROLS
Crankshaft Position Sensor Output Wave
Inspection
1. Measure the output wave between the ECM
terminals No. 99 and No. 100 using the scan tool or
the oscilloscope while engine cranking (start motor
activated).
Notice: Check the segment or crankshaft position
sensor and air gap if cannot get the output wave
as shown in the figure.
Crankshaft Position Sensor Insulator
Resistance Inspection
1. Disconnect the coupling from ECM while the ignition
switch is in "OFF" position.
2. Measure the resistance between the coupling
terminal pin No. 100 and No. 69 using a multimeter.
Specified Value
Notice: Measure the check and ground terminal of
the CKP sensor if out of the specified value.
>20 kΩ
YAD1F130
SSANGYONG Y200