Ebd Indicator Lamp Inoperative - SSANGYONG Rexton Y200 Manual

4E-28 ABS AND TCS
ELECTRONIC BRAKE-FORCE DISTRIBUTION SYSTEM (EBD) INDICATOR
Circuit Description
Battery voltage is supplied to the EBD warning lamp
with the ignition in ON or START. The warning lamp
can be activated only by the ABS control module
internally supplying ground to terminal 21.
Diagnosis
This procedure checks for a problem in the wiring, a
faulty ground, a voltage supply problem, a burned out
indicator lamp, or a contact problem in a connector.
Cause
•
A fuse has blown.
•
The indicator lamp has burned out.
•
There is a corroded or broken connector terminal.
•
There is a faulty ground connection.
•
There is a broken wire in a wiring harness.
•
The EBCM is faulty.
LAMP INOPERATIVE
Test Description
The number(s) below refer to step(s) on the diagnostic
table.
1. This test checks for any DTCs that may cause the
EBD indicator lamp to be inoperative.
2. This test verifies an inoperative lamp condition.
3. This test checks for voltage on the lamp circuit.
4. This begins a series of tests of the circuit from
the indicator lamp to the EBCM and ground.
19. This begins a series of tests of the voltage supply
circuits that power the indicator lamp.
YAD4E150
SSANGYONG Y200