SSANGYONG Rexton Y200 Manual page 1057

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-189
4. Check the clutch pack clearance using 0555-
336260 clutch pack clearance kit.
5. Use selective plates to achieve the correct specifi-
cation.
Notice: With the clutch pack supporting a 2 kg
weight, the dimension from the input shaft locating
stop to the friction disc must be 0.70 - 0.90 mm.
6. If new friction plates are being fitted, remove the
clutch pack and soak the friction elements in auto-
matic transmission fluid for a minimum of five
minutes prior to assembly.
Notice: The clutch pack clearance must be taken
KAA5A0Z0
before elements are soaked in automatic
transmission fluid.
7. Check the fit of the C1 clutch hub on the overdrive
shaft. If it is loose, the hub and shaft assembly
must be replaced.
8. Coat the small nylon thrust spacer with petroleum
jelly and install it over the overdrive shaft.
9. Carefully fit the overdrive shaft into the C1 cylinder
so as not to damage the sealing ring.
10. Fit the small bronze C1 hub thrust washer in place
with petroleum jelly.
11. Check the input shaft for any defect. Fit the input
shaft into the cylinder and secure it with the circlip,
ensuring that the circlip is completely seated in
KAA5A660 the groove.
12. Coat the sealing rings with petroleum jelly and fit
onto the input shaft.
KAA5A1A0