Table of Contents
Advertisement
SSANGYONG Y200
YAD1FBH0
YAD1FBJ0
0 T
10
20
30
40
YAD1BC10
DIESEL ENGINE CONTROLS 1F3-33
Tools Required
617 589 08 21 00 Position Sensor
Test Procedure
1. Remove the screw plug (5) and seal (4) and collect
oil in a suitable vessel.
Installation Notice
Tightening Torque
2. Install the position sensor 617 589 08 21 00 (1)
into the governor housing of the injection pump to
be the guide pin of the position sensor facing up.
3. Connect the battery terminal of position sensor
617 589 08 21 00 (1) to positive terminal (+) of
battery.
4. Rotate the crankshaft by hand (in direction of
engine rotation) until the lamp 'B' lights up.
Rotate the crankshaft carefully further until both
lamps 'A and B' come on. In this position, check
the Rl value on the crankshaft vibration damper.
Specification
Notice: If only lamp 'A' lights up, repeat the test
and if out of specification, adjust start of delivery.
30 N•m (22 lb-ft)
ATDC 14° - 16°
Advertisement
Chapters
Table of Contents
