Table of Contents
Advertisement
1B3-76 DIESEL ENGINE MECHANICAL
24. Insert the new connecting rod bearing shells into
the connecting rod and connecting rod bearing
cap and tighten the 12-sided stretch bolts (11).
Installation Notice
Tightening Torque
25. Measure inner diameter of connecting rod bearing.
YAD1BF20
26. Measure connecting rod bearing journal diameter
(K).
Notice: Refer to measurement of the crankshaft
bearing journal diameter.
27. Measure the radial clearance (L) of the connecting
rod bearing.
Example) Measured value 'J' = 47.700 mm
Radial Clearance 'L'
YAD1BF30
Notice: If the clearance is out of standard, adjust
the radial clearance of connecting rod bearing by
replacing the connecting rod bearing shells.
28. Remove the connecting rod bearing cap.
29. Install the piston.
30. Rotate the crankshaft by hand and check whether
it rotates smoothly.
31. If the bearings are damaged,
- replace the oil presser relief valve.
- clean the oil pump and oil filter housing carefully
and replace the hose if necessary.
Notice: After assembling the engine, check the
camshaft timing, adjust the start of fuel injection
and check the TDC sensor bracket setting.
32. Fill oil and run the engine and then check the oil
pressure and oil level.
Notice: Install the original oil filter element and
then change the engine oil and oil filter element
after 1,000 - 1,500 km.
35 N•m (26 lb-ft)+ 90°
Measured value 'K' = 47.653 mm
Clearance 'L'
= 0.047 mm
0.026 - 0.068 mm
SSANGYONG Y200
Advertisement
Chapters
Table of Contents
