SSANGYONG Rexton Y200 Manual page 188

SSANGYONG Y200
M161 ENGINE MECHANICAL 1B2-27
Tools Required
617 589 00 10 00 Allen Wrench Socket
116 589 20 33 00 Sliding Hammer
116 589 01 34 00 Threaded Pin
111 589 03 15 00 Holding Pin
Removal & Installation Procedure
1. Rotate the crankshaft so that the piston of number
1 cylinder is at ATDC 20.
YAD1B6D0
2. Put the holding pin 111 589 03 15 00 into the cam-
shaft bearing cap (number 1, 6).
YAD1B6E0
3. Put the alignment marks (arrows) on the timing
chain and camshaft sprocket.
4. Remove the chain tensioner.
Installation Notice
Tightening Torque
YAD1B6F0
5. Remove the exhaust camshaft sprocket.
Installation Notice
Tightening Torque
Notice: The flange bolt is designed to be used
only once, so always replace with new one.
YAD1B6G0
72 - 88 N•m
(53 - 65 lb-ft)
1st step: 18 - 22 N•m
(13 - 16 lb-ft)
2nd step: 60° ± 5°