SSANGYONG Rexton Y200 Manual page 1029

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-161
12. Remove the service hole cover in the engine block.
13. Put the alignment mark for installation, and remove
the six mounting bolts for torque converter from
drive plate through the service hole by rotating
the engine and remove the torque converter.
Installation Notice
Tightening Torque
•
Screw the six bolts mounting the torque converter
through the service hole by using a mirror and
rotating the engine.
14. Remover the starter. Refer to Section 1E, Engine
KAA5A2N0
Electrical.
15. Remove the extension housing to case bolts and
remove the transmission assembly.
Installation Notice
Tightening Torque
•
Be careful not to drop the torque converter while
removing the transmission.
16. Installation should follow the removal procedure
in the reverse order.
YAD5A150
42 N•m (31 lb-ft)
55-65 N•m (41-48 lb-ft)