SSANGYONG Rexton Y200 Manual page 1055

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-187
Notice: With the clutch pack supporting a weight
of 2kg, the clearance between the snap ring and
the top of the pressure plate is to be between 1.07
- 1.45 mm.
15. If new friction plates are being fitted, remove the
clutch pack and soak the friction elements in auto-
matic transmission fluid for a minimum of five min-
utes prior to reassembly.
Notice: The clutch pack clearance must be taken
before the elements are soaked in automatic
transmission fluid.
KAA5A0TA
Forward Sun Gear and C3 Clutch Pack
Assembly
1. Fit the No.7 needle bearing assembly over the for-
ward sun gear, ensuring that the thrust washer is
between the bearing and the sun gear.
2. Lubricate the lipped thrust plate with petroleum
jelly and fit the thrust plate onto the reverse sun
gear.
KAA5A0U0
3. Align and fit the C3 clutch assembly over the for-
ward sun gear.
KAA5A0V0
4. Lubricate the No.6 needle bearing with petroleum
jelly and fit it to the thrust plate. Ensure the lugs
on the outside diameter of the bearing fit in the
thrust plate counterbore.
5. Align and fit the plastic thrust washer to the thrust
plate with petroleum jelly.
6. Install the assembly over the forward sun gear
shaft against the No. 6 needle bearing.
7. Place the assembly to one side.
KAA5A0W0