SSANGYONG Rexton Y200 Manual page 1044

Hide thumbs Also See for Rexton Y200:

Table of Contents

5A-176 AUTOMATIC TRANSMISSION

19. Position the wiring loom and locate the solenoid 7

contact and terminal in the pump mounting flange

at the front of the case. The solenoid 7 wire is

routed under the park rod and cross shaft in the

20. Install the 10 pin connector in the case engaging

the tangs on the connector in the notches in case.

Output Shaft and Gear Assembly

1. Check that the output shaft bush is not worn or

damaged. Replace if necessary.

2. Check for damage to parking pawl teeth on the

ring gear. Replace if necessary.

3. Check that the sealing ring grooves have not been

4. Lubricate the sealing rings with automatic

transmission fluid.

5. Assemble the sealing rings to the output shaft with

the scarf cut uppermost.

6. If previously dismantled, assemble the ring gear

to the output shaft and secure with circlip. Ensure

that the circlip is firmly seated in its groove.

7. Install the No. 10 needle bearing assembly onto

the output shaft using petroleum jelly.

8. Carefully install the output shaft assembly in the

case to prevent damage to the sealing rings.

SSANGYONG Y200

Chapters

Table of Contents