SSANGYONG Rexton Y200 Manual page 333

SSANGYONG Y200
DIESEL ENGINE MECHANICAL 1B3-65
Installation Procedure
1. Throughly clean the sealing surface of end cover
and apply Loctite 573.
2. Clean the groove of radial seal.
3. Apply Loctite 573 on the bolts and install the end
cover.
Installation Notice
Tightening Torque
Be careful not to damage the oil pan gasket.
YAD1BEA0
4. Install the inner oil seal assembler 601 589 03 43
00 to the crankshaft flange.
YAD1BEB0
5. Coat a little oil on the sealing lip of new radial seal
and contacting surface.
Notice: Don't use grease.
6. Insert the new radial seal (4) on to the oil seal
assembler 601 589 03 43 00 (7).
YAD1BEC0
Notice: The sealing lip of the repair radial seal is
offset to the inside by 3 mm to ensure that is does
not run in any groove which the standard radial
seal may have left on the crankshaft flange.
A Standard Radial Seal
B Repair Radial Seal
YAD1BED0
10 N•m (89 lb-in)