Fuel Filter - SSANGYONG Rexton Y200 Manual

1F2-86 M161 ENGINE CONTROLS
8. Using the fuel tank cap wrench 661 589 00 46 00,
remove the locking cap.
9. Remove the pump from the fuel tank.
Notice: Check the condition of the seal and
replace if necessary. Drain the fuel before
removing the pump.
10. Perform an operational check of the fuel pump.
11. Installation should follow the removal procedure
in the reverse order.
YAA1F550

FUEL FILTER

Removal and Installation Procedure
1. Disconnect the negative battery cable.
Caution: The fuel system is under pressure. To
avoid fuel spillage and the risk of personal injury
or fire, it is necessary to relieve the fuel system
pressure before disconnecting the fuel lines.
2. Relieve the fuel system pressure. Refer to "Dis-
charging the Pressure in Fuel System" in this sec-
tion.
3. Disconnect the fuel lines from the fuel filter.
YAA1F190
Installation Notice
Tightening Torque
4. Remove the fuel filter mounting bracket bolt .
Installation Notice
Tightening Torque
Notice: Place the fuel pump pad. There may be
acorrosion due to the contact between the fuel filter
and the bracket.
5. Remove the fuel filter.
6. Install the fuel filter.
7. Perform a leak test of the fuel filter.
8. Installation should follow the removal procedure
in the reverse order.
28 N•m (21 lb-ft)
6 N•m (53 lb-in)
SSANGYONG Y200