Throttle Body; Actuator) - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200
M161 ENGINE CONTROLS 1F2-91
THROTTLE BODY (INTEGRATED
WITH THE ACTUATOR)
Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the intake air temperature (IAT) sensor
connector.
3. Remove the intake air duct clamps.
KAC1F250
4. Remove the blow-by hose.
5. Remove the intake air duck.
KFC1F240
6. Disconnect the throttle body electrical connector.
7. Remove the throttle body bolts.
Installation Notice
Tightening Torque
8. Remove the vacuum hose.
YAA1F790
9. Remove the throttle body and discard the gasket.
Important: Use care in cleaning old gasket
material. Sharp tools may damage sealing
surfaces.
10. Installation should follow the removal procedure
in the reverse order.
KAA1D240
12 N•m (106 lb-in)