Dtc 800-Low Voltage Fault - SSANGYONG Rexton Y200 Manual

Step
Check the voltage at the battery.
1
Is the voltage within the specified value?
Charge or replace the battery, as required.
2
Is the repair complete?
Check fuse SB2 in the engine fuse block.
3
Is the fuse blown?
1. Replace fuse SB2.
4
2. Turn the ignition to ON.
Does the fuse blow again?
1. Turn the ignition to OFF.
2. Trace the wires in the ABS wiring harness from
terminal SB2 at the engine fuse block to the
5
terminal 17, 18 in EBCM.
3. Repair any short circuit found along this path.
Is the repair complete?
1. Turn the ignition to OFF.
2. Install the scan tool.
3. Clear all DTCs.
6
4. Road test the vehicle.
Does DTC 800 reset?
Check terminal 1 in the C101 connector.
7
Is the connection good?
Repair the terminal.
8
Is the repair complete?
1. Turn the ignition to OFF.
2. Install the scan tool.
3. Clear all DTCs.
9
4. Rood test the vehicle.
Does DTC 800 reset?
Check fuse F7 in the I/P fuse block.
10
Is fuse F7 blown?
1. Replace fuse F7.
2. Turn the ignition to ON.
11
Does fuse F7 blow again?
1. Turn the ignition to OFF.
2. Trace the WHT/RED wires in the ABS wiring
harness from fuse F7 to terminal 15 of the EBCM
12
connector.
3. Repair any short circuit found along this path.
Is the repair complete?
1. Turn the ignition to OFF
2. Install the scan tool.
13 3. Clear all DTCs.
4. Rood test the vehicle.
Does DTC 800 reset?
SSANGYONG Y200
DTC 800 - Low Voltage Fault
Action
ABS AND TCS 4E-83
Value Yes
11 - 14 V Go to Step 3
- System OK
- Go to Step 4
- Go to Step 5
- System OK
- System OK
- Go to Step 8
- System OK
- System OK
- Go to Step 11
- Go to Step 12
- System OK
- System OK
No
Go to Step 2
-
Go to Step 7
Go to Step 6
-
-
Go to Step 10
Go to Step 9
-
Go to Step 14
Go to Step 13
-
-