Table of Contents
Advertisement
Step
Use the scan tool to determine if any other DTCs are
set.
1
Are other DTCs set?
Clear all DTCs and road test the vehicle.
2
Does DTC 550 set again?
1. Check all wiring harness connectors and terminals,
especially those at the EBCM, for any condition
that could cause an intermittent.
3
2. Repair any problems found.
Is the repair complete?
1. Turn the ignition to OFF.
2. Disconnect the EBCM connector.
3. Turn the ignition to ON.
4
4. Measure the voltage between ground and terminals
15, 17 and 18 of the EBCM harness connector.
Is the voltage equal to the specified value?
1. Check the voltage supply and the ground
connections to the EBCM.
5
2. Repair any open or high resistance found.
Is the repair complete?
Check the EBCM connector for any damaged
terminals.
6
Are there any problems?
Repair any connector problem found.
7
Is the repair complete?
Clear all DTCs and road test the vehicle.
8
Does DTC 550 set again?
Replace the EBCM.
9
Is the repair complete?
SSANGYONG Y200
DTC 550 - EBCM Internal Fault
Action
ABS AND TCS 4E-87
Value
Yes
Go to the
applicable
Diagnostic
-
Table
-
Go to Step 4
-
System OK
11 - 14 V
Go to Step 6
-
System OK
-
Go to Step 7
-
System OK
-
Go to Step 9
-
System OK
No
Go to Step 2
Go to Step 3
-
Go to Step 5
-
Go to Step 8
-
System OK
-
Advertisement
Chapters
Table of Contents
