SSANGYONG Rexton Y200 Manual page 773

3A-24 FRONT AXLE
5. Install the differential carrier assembly into the axle
housing. Set up the bearing cap and then tighten
the cap bolts.
Installation Notice
Tightening Torque
Notice: Be careful not to change the caps. Be sure
to keep the original position of the caps.
YAD3A600
6. Measure the backlash of drive pinion and ring
gear.
Specified value
YAD3A610
7. Install the axle housing cover. Tighten the fixing
bolts.
Installation Notice
Tightening Torque
YAD3A620
8. Assemble the parts of the front axle inner shaft
and housing mounting bracket.
Notice: Apply the grease to the oil seal rib.
YAD3A630
48 - 69 N•m
(35 - 51 lb-ft)
0.13 - 0.20 mm
39 - 46 N•m
(29 - 34 lb-ft)
SSANGYONG Y200