Fuel Tank - SSANGYONG Rexton Y200 Manual

Hide thumbs Also See for Rexton Y200:

Table of Contents

SSANGYONG Y200

M162 ENGINE CONTROLS 1F1-85

FUEL TANK

Removal and Installation Procedure

Caution: The fuel system is under pressure. To avoid

fuel spillage and the risk of personal injury or fire,

it is necessary to relieve the fuel system pressure

before disconnecting the fuel lines.

1. Relieve the fuel pressure. Refer to "Discharging

the Pressure in Fuel System" in this section.

2. Disconnect the negative battery cable.

3. Drain the fuel tank.

4. Put aside the floor carpet to remove the fuel pump

access cover.

5. Remove the fuel pump access cover.

6. Disconnect the return line.

7. Disconnect the supply line.

8. Disconnect the fuel tank-to-canister hose from the

9. Disconnect the fuel pump wiring connector.

10. Disconnect the fuel filler hose and air vent hose

from the fuel tank.

11. Support the fuel tank.

12. Remove the fuel tank retaining nuts.

Installation Notice

Tightening Torque

13. Carefully lower the fuel tank.

38 N•m (28 lb-ft)

Table of Contents