SSANGYONG Rexton Y200 Manual page 419

1B3-150 DIESEL ENGINE MECHANICAL
Tools Required
001 589 53 21 00 Dial Gauge
363 589 02 21 00 Dial Gauge Holder
366 589 00 21 05 Extension
Measurement Procedure
1. Remove the cylinder head cover.
2. Rotate the engine in the direction of engine rotation
until the intake valve of no. 1 cylinder is completely
closed. The cam lobe faces up (arrow).
Notice: Do not rotate the engine at the bolt of the
crankshaft sprocket. Do not rotate the engine in
YAD1BK10
the opposite direction of engine rotation. If do,
this will cause serious measuring errors.
3. Install the dial gauge holder 363 589 02 21 00 and
dial gauge 001 589 53 21 00 (7) with the extension
366 589 00 21 05 (8) to the cylinder head and
position the tracer pin (9) onto the valve tappet
(intake valve of cylinder no.1) with a preload of
min. 3mm.
Notice: The tracer pin should be positioned exactly
vertical.
YAD1BK20
4. Set the dial gauge to '0'.
5. Rotate the engine further in direction of rotation
until the dial gauge has moved back by 2 mm
(valve lift) to 1mm.
6. Check the timing.
After approx.
Notice: If timing is out of standard, the camshaft
should be checked for wear and the timing chain
for stretch. If a difference of more than 4° exists,
the timing chain should be replaced.
YAD1BC10
7. Replace the gasket and install the cylinder head
cover.
Installation Notice
Tightening Torque
New
ATDC 11.33°
ATDC 12°
10 N•m (89 lb-in)
SSANGYONG Y200