SSANGYONG Y200
Installation
Clean all the parts. Check O-ring, snap ring for the
wear and damage.
If damaged, replace them with new ones.
1. Inser t the axle shaft to the axle housing. Be sure
to insert the axle shaft to the housing.
Notice: When you insert the axle shaft, be careful
not to damage the boots.
2. Install the steering knuckle to the axle shaft
exactly.
YAD3A200
3. Install the steering knuckle to the upper/lower arm
and fix the split pin.
Installation Notice
Tightening
Torque
YAD3A170
4. Install the dust shield to the knuckle.
YAD3A210
5. With full time transfer case only
•
Install the hub assembly to the axle shaft and
tighten the hexagon bolts applied the lock tight
(Blue color).
Installation Notice
Tightening Torque
YAD3A220
FRONT AXLE 3A-15
Lower arm
140 - 160 N•m
Upper arm
140 - 160 N•m
100 - 130 N•m