Pedal Position Sensor; Oxygen Sensor - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200
M162 ENGINE CONTROLS 1F1-91

PEDAL POSITION SENSOR

Removal and installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the pedal position sensor connector.
3. Unscrew the bolts and nut.
Installation Notice
Tightening Torque
4. Remove the pedal and sensor assembly.
5. Installation should follow the removal procedure
KAA1F410
in the reverse order.

OXYGEN SENSOR

Removal and Installation Procedure
1. Disconnect the negative battery cable.
Notice: The oxygen sensor uses a permanently
attached pigtail and connector. This pigtail should
not be removed from the oxygen sensor. Damage
or removal of the pigtail or the connector could
affect proper operation of the oxygen sensor. Do
not drop the oxygen sensor.
2. Disconnect the electrical connector.
3. Carefully remove the oxygen sensor from the
YAD1F640
exhaust pipe.
Installation Notice
Tightening Torque
Important: A special anti-seize compound is used
on the oxygen sensor threads. This compound
consists of a liquid graphite and glass beads. The
graphite will burn away, but the glass beads will
remain, making the sensor easier to remove. New
or serviced sensors will al-ready have the
compound applied to the threads. If a sensor is
removed from any engine and is to be rein-stalled,
the threads must have an anti-seize compound
applied before reinstallation.
4. Coat the threads of the oxygen sensor with an anti-
seize compound, if needed.
5. Installation should follow the removal procedure
in the reverse order.
6 N•m (53 lb-ft)
55 N•m (41 lb-ft)